Sheet metal shop steel going strong
The rough sketch for a replacement duct in building 26006 is placed on a table to be used as a reference March 25, 2014, on Andersen Air Force Base, Guam. Prior to installation, job schematics are first sketched, verified and then cut into the appropriate pattern out of sheet metal. (U.S. Air Force photo by Senior Airman Katrina M. Brisbin/Released)
PHOTO BY:
Senior Airman Katrina M. BrisbinReleased
VIRIN:
140325-F-EP111-072.JPG
FULL SIZE:
2.28 MB
CAMERA
N/A
LENS
N/A
APERTURE
N/A
No camera details available.
IMAGE IS PUBLIC DOMAIN
Read More
This photograph is considered public domain and has been cleared for release.
If you would like to republish please give the photographer appropriate credit.
Further, any commercial or non-commercial use of this photograph or any other
DoD image must be made in compliance with guidance found at
https://www.dimoc.mil/resources/limitations,
which pertains to intellectual property restrictions (e.g., copyright and
trademark, including the use of official emblems, insignia, names and slogans), warnings
regarding use of images of identifiable personnel, appearance of endorsement, and related matters.